3.Attach the Latch Assembly (82) to the Left Upright (84) with the two Latch Screws (134). Start both Latch Screws before tightening either of them. Note: The Latch Screws may be preattached to the Left Upright.
4.Refer to step 6 and locate the four Upright Bolts (86). Loosen the Upright Bolts two to three turns.
With the help of a second person, hold the Console Base (101) near the Uprights (80, 84).
Cut the plastic ties holding the Wire Harness (74) and the Pulse Wire (70) in the Uprights (80, 84). Connect the Wire Harness and the Pulse Wire to the connectors on the sides of the Console Base (101). Make sure to con- nect the connectors properly (see the inset draw- ings). IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. The connectors should slide together easily and “snap” into place. If the connectors do not slide together easily and snap into place, turn a connector and try again. Insert the excess Wire Harness and Pulse Wire up into the Console Base.
Press the Right and Left Top Endcaps (75, 81) into the Uprights (80, 84) as shown.
5.Set the Console Base (101) on the Uprights (80, 84). Attach the Console Base to the each Upright with two Upright Bolts (76) and two Internal Star Washers (77). Be careful not to pinch the Wires (not shown) in the Uprights. Note: Start all four Upright Bolts before tight- ening any of them.
Make sure that the Left and Right Trays (109, 111) are pressed into the Console Base (101).
3 |
|
|
| 134 | 82 |
|
| |
| 84 |
|
4 |
|
|
| 74 | 70 |
|
| |
| 101 | 81 |
| 75 |
|
| 80 | 84 |
|
| |
5 |
| 101 |
|
| 84 |
| 111 | 109 |
| 77 | 77 |
|
| |
|
| 77 |
76 | 80 | 76 |
6
