ProForm 831.293201 user manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons.Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches		and your own phillips screwdriver
and wire cutters	.

1. Make sure that the power cord is unplugged.			1
To identify small parts, use the PART IDENTIFICA-
TION CHART on page 27.		Note: If a part is not in the
parts bag, check to see if it has been pre-assembled.			If
a part is missing, call toll-free 1-800-999-3756.
With the help of a second person, carefully raise the
Upright Base (97) to the position shown. Insert one of
the Extension Legs (92) into the Upright Base. (Note: It
may be helpful to tip the Upright Base forward as you in-
sert the Extension Leg.) Make sure that the Warning
Decal (91) is in the indicated location.
Insert the other Ext	ension Leg (not shown) in the same
way.
				91
				97
				92
2. With the help of a second person, carefully tip the			2
Upright Base (97) down as shown. (Note: It may be help-						99
ful to place your foot on one of the Extension Legs [92]
as you tip the Uprights.)		Make sure that the Extension
Legs remain in the Uprights.						40
Attach each Extension Leg (92) with two Extension Leg				99
Bolts (96) and two 1/4” Washers (39) as shown. Thread						96
a Leveling Foot (95) into each side of the Upright Base
				40		95
(97); do not thread the Leveling Feet fully into the
					39
Upright Base.
Attach the two Base Pads (99) to the Upright Base (97)				97	92	96
in the locations shown with two 1” Tek Screws (40).
				39
With the help of a second person, raise the Upright Base				96
			97
(97) to the vertical position.				95
			92	3996
			5