2.With the help of a second person, carefully tip the Uprights (97) down as shown. (Note: It may be helpful to place your foot on one of the Extension Legs [92] as you tip the Uprights.) Make sure that the Extension Legs remain in the Uprights.

Attach each Extension Leg (92) with two Extension Leg Bolts (96) and two 1/4” Washers (39) as shown. Thread a Leveling Foot (95) into each side of the Upright Base (97); do not thread the Leveling Feet fully into the

Upright Base.

Attach the two Base Pads (99) to the Upright Base (97) in the locations shown with two 1” Tek Screws (80).

With the help of a second person, raise the Upright Base (97) to the vertical position.

3.Attach the Latch Assembly (82) to the left Upright (97) with the two Latch Screws (79); start both Latch Screws before tightening either of them. Note: The Latch Screws may be preattached to the left Upright.

4.See drawing 4c. With the help of a second person, hold the Console Base (101) near the Uprights (80, 84). Look under the Console Base and locate the wires on the sides of the Console Base. Make sure that the wires are not routed through the openings for the Trays (109,

111). Drawing 4a shows the correct route for the wires. Drawing 4b shows an incorrect route.

See drawing 4c. Cut the plastic ties holding the Wire Harness (74) and the pulse wire in the Uprights (97).

Locate the Wire Harness (74) and the pulse wire in the Uprights (97). Connect the Wire Harness and the pulse wire to the connectors on the sides of the Console Base (101). Make sure to connect the connectors properly (see the inset drawings). The connectors should slide together easily and snap into place. If the con- nectors do not slide together easily and snap into place, turn one connector and try again to insert it. IF THE

CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the excess Wire Harness and pulse wire up into the Console Base.

2

 

 

 

 

99

 

 

 

 

 

 

 

 

 

 

80

 

99

 

 

 

 

 

 

 

 

 

96

 

 

80

 

 

95

 

 

 

 

39

 

 

 

 

97

92

96

 

 

 

 

 

 

 

 

 

 

39

96

 

 

 

97

 

 

 

 

 

95

 

 

 

 

 

 

 

 

92

39

96

 

 

 

3

 

 

 

 

 

 

79

82

 

 

 

 

 

 

 

 

 

 

 

 

97

 

4a

 

 

4b

 

 

 

Correct

 

 

Incorrect

 

4c

 

 

 

 

 

 

111

109

 

 

74

101

 

 

 

 

 

 

 

 

 

97

 

 

97

 

 

Pulse

74

Wire

 

6

Page 6
Image 6
ProForm 831.295062 user manual Upright Base