5.Attach four Base Pads (99) to the base of the Uprights (97) with four Base Pad Screws (40) in the locations shown.
6.Attach the two Wheels (94) to the base of the Uprights (97) with two Wheel Bolts (90), four Wheel Spacers (79), and two Nuts (20) as shown. Do not overtighten the
Nuts; the Wheels must be able to turn freely.
With the help of a second person, carefully raise the Uprights (97) to the vertical position.
5 |
|
| 99 |
|
|
| |
|
|
| 40 |
|
|
| 99 |
99 |
| 40 |
|
|
| 40 | |
|
|
| |
|
| 97 |
|
99 | 40 |
|
|
6 |
| 94 | 79 |
|
| ||
| 97 | 79 | 90 |
|
| ||
|
| 20 |
|
94 | 79 |
|
|
79 |
|
| |
20 |
|
| |
|
|
| |
90 |
|
|
|
7.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 23). To protect the floor or carpet, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the receiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screw (95) and the Access Door (96) from the left side of the Console Base (101).
2.Connect the wire on the receiver (A) to the indicated wire extending from the Console Base (101). Hold the re- ceiver so the small cylinder is oriented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door (96) with the two in- cluded small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (96) with the Screw (95). Discard the other wires included with the receiver.
|
| Wire |
101 |
| Small |
|
| Screws |
96 |
|
|
| A | Small |
95 |
| |
| Cylinder |
7