![](/images/new-backgrounds/1271319/27131915x1.webp)
CONSOLE DIAGRAM
Displays
Key
Speed Control
Clip
CAUTION:
Before operating the console, read the following precautions.
¥Do not stand on the walk- ing belt when turning on the power.
¥Always wear the clip (see the drawing at the left) while using the treadmill. When the key is removed from the console, the walking belt will stop.
¥Adjust the speed in small increments.
¥The training zones marked beside the speed control are general guidelines only. See page 14 for more information.
¥To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the con- sole and use only a seal- able water bottle.
BATTERY INSTALLATION | STEP BY STEP CONSOLE OPERATION |
The console requires three "AA" batteries (not in- cluded). Alkaline batteries are recommended. Open the battery cover as shown below. Insert three batter- ies into the battery compartment, making sure that the negative (Ð) ends of the batteries are touching the springs in the battery compartment. Close the bat- tery cover, push up on the battery cover tab, and then push the tab forward as shown. Be sure that the tab locks into place.
Battery |
|
Cover |
|
Batteries | Battery |
Cover Tab |
If there is a thin sheet of clear plastic on the face of the console, remove it.
Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7.)
Next, step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing.
Follow the steps on the page 8 to operate the console.
8