The program display will show the first speed settings for the pro- gram. The Time/ Incline/Segment Time display will show how long the program will last.
3 Press the Start button or the Speed ▲ button to start the program.
A moment after the button is pressed, the tread- mill will automatically adjust to the first speed and incline settings for the program. Hold the handrails and begin walking.
Each program is divided into several time seg- ments of different lengths. The Time/Incline/ Segment Time display shows both the time re- maining in the program and the time remaining in the current segment. One speed setting and one incline setting are pro-
grammed for each seg- ment. The speed set-
ting for the first seg- ment will be shown in the flashing Current
Segment column of the program display. (The
incline settings are not
shown in the program display.) The speed set- tings for the next four segments will be shown in the four columns to the right.
When only three seconds remain in the first seg- ment of the program, both the Current Segment column and the column to the right will flash and a tone will sound. In addition, if the speed and/or incline of the treadmill is about to change, the
The program will continue in this way until the speed setting for the last segment is shown in the Current Segment column and no time remains in the Time/Incline/Segment Time display. The walk- ing belt will then slow to a stop.
Note: Each time a segment ends and the speed settings move one column to the left, if all of the indicators in the Current Segment column are lit, the speed settings will move downward so that only the highest indicators in the columns will appear in the program display. When the speed settings move to the left again and not all of the indicators in the Current Segment column are lit, the speed settings will move back up.
If the speed or incline setting for the current segment is too high or too low, you can manually override the setting by pressing the Speed or Incline buttons on the console. Every few times one of the Speed buttons is pressed, an additional indicator will light or darken in the Current Segment column. If any of the columns to the right of the Current Segment column have the same number of lit indicators as the Current Segment column, an additional indicator may light or darken in those columns as well. Important: When the current segment of the program ends, the treadmill will automatically adjust to the speed and incline settings for the next segment.
To stop the program temporarily, press the Stop button. The Time/Incline/Segment Time display will begin to flash. To restart the program, press the Start button or the Speed ▲ button. To end the program, press the Stop button, remove the key, and then reinsert the key.
4 Follow your progress with the displays.
See step 5 on page 11.
5 Measure your heart rate, if desired.
See step 6 on page 12.
6 When the program is completed, remove the key from the console.
When the program has ended, make sure that the incline of the treadmill is at the lowest set- ting. Next, remove the key from the console and put it in a safe place. Note: If the displays and various indicators on the console remain lit after the key is removed, the console is in the “demo” mode. See page 19 and turn off the demo mode.
When you are finished using the treadmill, move the on/off switch near the power cord to the off position and unplug the power cord.
13
