2.Remove the plastic ties and the wood brace from the Uprights (109).
Identify the left handrail, which has a hole in the indi- cated location, and the right handrail. Hold the right handrail near the right Upright (109), and insert the Wire Harness (83) into the large hole in the right handrail and out of the upper end as shown.
Next, hold the right handrail against the right Upright
(109).Tighten a 4” Bolt (112) three to four turns into the right Upright and the lower end of the right handrail. Tighten two 5/16” x 1” Bolts (122) into the upper end of the right handrail and the right Upright. Be careful not to drop the Bolts into the handrail. If necessary, raise or lower the handrail to thread the Bolts into the Upright.
Firmly tighten all three Bolts.
Attach the left handrail as described above. Note: There is not a wire harness in the left Upright (109).
3.With the help of another person, hold the console as- sembly near the right Upright (109) and the left Upright (not shown).
Connect the Wire Harness (83) to the wire harness in the console assembly. Make sure to connect the con- nectors properly (see the inset drawing); the con- nectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try to connect them again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER IS TURNED ON. Insert the excess wire harness back into the right handrail.
Set the console assembly on the right Upright (109) and the Left Upright (not shown). Thread two 1/4” x 1” Bolts
(71)with 1/4” Star Washers (92) into each side of the console assembly. After you have started all four
Bolts, tighten them.
2 |
|
|
122 |
| Brace |
Left |
|
|
Handrail |
|
|
| 109 | 83 |
|
| |
| 122 |
|
Hole | Right |
|
| Handrail |
|
| 112 | 109 |
|
| |
|
| 112 |
3 |
|
|
| Console |
|
| Assembly |
|
| 83 |
|
Right Handrail 
109 | 92 |
71
83
7
