4. Position the Base (52) as close to the front of the

4

 

 

 

 

 

treadmill as possible, as shown.

39

 

39

 

54

See the upper inset drawing. Locate the wire

 

 

 

tie in the lower end of the Right Upright (54). Tie

 

 

 

 

Wire Tie

the wire tie securely around the end of the Wire

 

54

 

 

Harness (39). Then, locate the other end of the

 

 

 

 

 

wire tie in the upper end of the Right Upright.

 

 

 

 

 

 

Pull the upper end of the wire tie until the Wire

 

52

 

 

 

 

Harness is extending from the upper end of the

 

 

 

 

 

Right Upright. Secure the Wire Harness to the

 

 

 

52

 

 

Right Upright so that it will not fall inside.

 

 

 

 

54

See the lower inset drawing. Press the indi-

 

 

 

 

 

cated Grommet (49) into the Right Upright (54).

 

 

 

 

 

 

 

 

 

 

39

49

 

 

 

 

 

 

 

5. See the left inset drawing. Identify the two

5

 

 

 

 

 

Frame Spacers (11). Open the included packet

 

 

 

 

 

of grease, and apply grease to both sides of both

 

 

 

 

 

 

Frame Spacers. Then, identify the outer side of

 

 

 

 

 

 

each Frame Spacer.

 

 

 

 

54

 

Hold a Frame Spacer (11) between the Right

 

 

 

 

 

Upright (54) and the Lift Frame (23), with the

 

 

 

 

 

 

outer side of the Frame Spacer facing the

 

 

 

 

 

 

Right Upright.

 

 

 

 

9

 

With the help of a second person, lift the front of

 

 

 

 

 

the treadmill. Attach the Lift Frame (23) to the

 

 

 

11

14

1

Right Upright (54) with an M10 x 60mm Patch

 

 

 

 

Bolt (1), an M10 Flat Washer (14), and an M10

 

 

23

 

 

 

Star Washer (9); do not fully tighten the Patch

 

 

 

 

 

Bolt yet.

 

Grease

 

Top View

 

 

 

 

 

 

 

11

 

11

14

1

 

 

 

 

9

 

 

 

Outer Side

 

23

 

 

 

 

 

54

 

 

8

 

 

 

 

 

Page 8
Image 8
ProForm PATL49708.0 user manual See the upper inset drawing. Locate the wire, See the lower inset drawing. Press the indi