6.See the left inset drawing in step 5. Identify the outer side of the remaining Frame Spacer (11).
Hold the Frame Spacer (11) between the Left Upright (53) and the Lift Frame (23), with the outer side of the Frame Spacer facing the Left Upright. Attach the Left Upright to the Lift Frame with an M10 x 60mm Patch Bolt (1), an M10 Flat Washer (14), and an M10 Star Washer (9); do not fully tighten the Patch Bolt yet.
7.Set the Console (91) face down on a soft sur- face to avoid scratching the Console. Hold the Right Handrail (33), which has a large hole in one side, near the Console.
Next, insert the console wire and the tie into the large hole in the side of the Right Handrail (33). Using needlenose pliers, pull the console wire out of the hole near the bracket on the Right Handrail.
Then, set the Right Handrail (33) on the Console (91). Make sure that no wires are pinched. Start an M5 x 16mm Screw (85) with an M5 Star Washer (7) into the Right Handrail, and then start two M4.2 x 19mm Screws (10) into the Right Handrail. Tighten the M5 x 16mm Screw and then tighten the two M4.2 x 19mm Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the Console (91) in the same way. Note: There are no wires on the left side.
6 |
|
|
|
| Top View |
|
|
|
|
| 1 | 14 | 11 |
|
|
|
|
| 9 | |
|
|
|
|
| 23 | |
| 53 |
|
|
| 53 |
|
|
|
|
|
|
| |
9 |
|
|
|
|
|
|
1 | 14 | 11 | 23 |
|
|
|
|
|
|
|
|
| |
7 |
| Console |
|
|
| |
|
| Tie Wire | 85 |
|
| |
| Bracket |
| 7 | 10 |
| |
33 |
| Large |
|
| ||
|
|
|
| |||
|
| Hole |
|
|
|
|
|
| 91 |
|
|
|
|
9
