ASSEMBLY
Place all parts of the AIR WALKER in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Read through all assembly steps before you begin.
Assembly requires an allen wrench 
(included) a phillips screwdriver 
and an adjustable wrench 
(not included).
1.Refer to figure 1b. Move to the front of the AIR WALKER and place your hands on the Frame (1) in the indicated locations. Hold the AIR WALKER in the position shown in figure 1a. Put your foot on the round tube. Using your foot, pull the round tube toward you until the Uprights (5, 6) come to rest against the stops. Make sure that the Uprights are completely extended and are resting against the stops before you proceed with assembly.
2.Slide a Lock Washer (16) onto the Lock Knob (32). Insert the Lock Knob (32) into the hole near the top of the Left Leg (2). Tighten the Lock Knob into the Link Plate (7).
3.The Electronic Monitor (9) requires two ÒAAÓ batteries (not included). Alkaline batteries are recommended. Press the tab on the battery cover and remove the battery cover from the Monitor. Insert two batteries into the Monitor. Make sure that the negative (Ð) ends of the batteries are touching the springs in the Console. Close the battery cover.
Fig. 1a |
| Fig. 1b | Hands |
Back | Front |
|
|
|
|
| 1 |
5 | Stop |
| Foot |
|
| ||
|
|
| |
6 |
|
|
|
| 1 |
|
|
|
| Round |
|
|
| Tube |
|
Fig. 2 |
|
|
|
| 16 | 32 |
|
7 | 2 |
|
|
Fig. 3 |
|
|
|
|
| 9 |
|
|
|
| Batteries |
|
|
| Battery |
|
| Tab | Cover |
4
