4.Connect the Reed Switch Wire (12) to the wire on the Electronic Monitor (9). Feed any excess wire into the Crossbar Cover (19). Press the Monitor onto the Crossbar so the Fasteners (48) on the Monitor snap into the holes in the Crossbar.
5.Slide one of the Handles (8) onto the Left Leg (2). Attach the Handle with two Button Head Screws (50) and two 1/4Ó Locknuts (23). Tighten the
Locknuts until the Handle cannot move. The Handle will be deformed slightly when the Locknuts are properly tightened.
Attach the other Handle (8) to the Right Leg (3) in the same manner.
6.The decal shown at the right is found in the indi- cated location on the AIR WALKER. If the decal is missing, or if it is not legible, call our Customer Service Department,
Make sure that all parts are properly tightened before you use the AIR WALKER.
Fig. 4 |
|
9 |
|
| 48 |
| 48 |
19 | 12 |
Fig. 5 |
|
| 8 |
| 50 |
23 | 8 |
| |
| 3 |
| Holes |
| 2 |
Fig. 6 |
|
5
