4.Identify the Ramp Axle (128), which is the longest axle. Slide a Ramp Axle Cover (132) onto an M6 x 18mm Button Screw (67) as shown. Tighten the Button Screw into one end of the Ramp Axle. Apply a small amount of the included grease to the Ramp Axle.
Have a second person hold the two Ramp Spacers (130) against the sides of the Frame (1) so they cover the indicated tubes on the Frame. See the inset draw- ing. Make sure that the Ramp Spacers are oriented as shown. Next, lift the Flex Bars (not shown) out of the way and align the round tubes on the Ramp (133) with the Ramp Spacers. Make sure that the Ramp is turned as shown. Insert the Ramp Axle (128) into the Ramp, the Ramp Spacers, and the Frame. Note: It may be helpful to use a rubber mallet.
Slide the other Ramp Cover (132) onto an M6 x 18mm Button Screw (67) as shown. Tighten the Button Screw into the other end of the Ramp Axle (128).
5.Identify the Incline Axle (137), which is the longest remaining axle. Slide an M6 Washer (58) onto an M6 x 18mm Button Screw (67). Tighten the Button Screw into one end of the Incline Axle. Apply a small amount of grease to the Incline Axle.
Raise the Ramp (133). Insert the Incline Axle (137) into one side of the Ramp, through an Incline Spacer (123), through the motor screw, through the other Incline Spacer, and then into the other side of the Ramp. As you insert the Incline Axle through the motor screw, make sure that the motor screw does not turn.
Slide an M6 Washer (58) onto an M6 x 18mm Button Screw (67). Tighten the Button Screw into the other end of the Incline Axle (137).
4 |
|
| Side View |
|
|
| Wide |
|
|
| End |
|
|
| Up |
|
|
| 130 |
133 |
|
|
|
|
|
| 67 |
|
|
| 1 |
|
|
| 132 |
|
|
| 130 |
Grease |
|
| |
132 |
| 130 | Tube |
67 |
| ||
128 |
|
| |
|
|
| |
5 |
|
|
|
|
| 123 |
|
133 |
|
| 67 |
|
| 58 | |
|
|
| |
Motor Screw |
|
| |
Grease |
|
| |
| 137 |
|
|
67 | 58 |
|
|
|
|
| |
7
