ASSEMBLY
Assembly requires | two people. | Place all parts of the elliptical exerciser in a cleared area | and remove the |
| ||
packing | materials. Do not dispose of the packing materials until assembly is completed. |
|
|
| ||
Assembly | requires | a phillips screwdriver | , two adju | stable | wrenches | , and a |
rubber mallet |
| . |
|
|
| |
1.While another person holds the Upright (3) near the Frame (1) as shown, gently pull the Resistance Cable
(26)and the Sensor Wire (25) out of the top of the Upright until there is no slack between the Upright and the Frame.
Slide the Upright (3) onto the welded bolts on the Frame (1). Be careful to avoid pinching the
Resistance Cable (26) and the Sensor Wire (25). Tighten an M10 Nylon Locknut (29) onto each welded bolt.
2.While another person holds the Console (6) near the Upright (3), connect the console wire to the Sensor Wire (25).
Feed the slack Sensor Wire (25) back down into the
Upright (3). Attach the Console (6) to the Upright (3)
1
2
26
25
3
29
Welded
1Bolts
6
50
with four M4 x 16mm Round Head Screws (38).Be careful to avoid pinching the Sensor Wire.
Press the Resistance Control Knob (50) onto the
Resistance Control (26).
Console
Wire
2526
38
3
6
