5.Connect the wire harness on the Handgrip Pulse Sensor (15) to the indicated wire harness on the Console (16). Insert both wire harnesses into the open- ing in the bottom of the Console. Then, insert the metal tube on the Handgrip Pulse Sensor into the opening in

the

bottom of the console.

Be careful not to pinch

the

wire harnesses.

 

Refer to the inset drawing. Tighten an M4 x 16mm

Screw (66) into the indicated bracket on the Console

(16)and into the metal tube on the Handgrip Pulse Sensor (15).

6.While another person holds the Console (16) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (36). Insert the excess wire harness into the Upright (13).

Attach the Console (16) to the Upright (13) with three M10 x 27mm Button Screws (51) and three M10 Black

Split Washers (50). Be careful to avoid pinching the wire harnesses.

Snap the bookrack onto the Console (16) where shown.

7.Turn the indicated Adjustment Knob (28) counterclock- wise two or three turns to loosen it. Next, pull the Knob, insert the Seat Post (5) into the Frame (1), and then

release the Knob. Move the Seat Post up and down slightly until the pin on the Knob snaps into one of

the holes in the Seat Post.

Then, turn the Knob clock-

wise until it is tight.

 

8.Attach the Seat (12) to the Seat Bracket (6) with four M8 Nylon Locknuts (10) and four M8 Split Washers (70). Note: The Nylon Locknuts and the Split Washers may be pre-attached to the underside of the Seat.

Turn the Seat Adjustment Knob (9) counterclockwise

two or three turns to loosen it. Next, pull the Knob, slide the Seat Bracket (6) into the top of the Seat Post (5),

and then release the Knob.

Move the Seat Bracket

forward and

backward slightly until the pin

on the

Knob snaps

into one of the holes in the Seat

 

Bracket. Then, turn the Knob clockwise until it is tight.

6

5

 

15

 

 

16

 

 

 

66

 

 

Bracket

16

 

 

 

Metal Tube

 

 

15

6

 

 

Bookrack

 

 

16

 

 

Wire Harness

 

 

36

 

Be careful

 

to avoid

51

51

50

 

pinching

50

the Wire

 

51

13

Harnesses.

7

 

 

 

5

 

1

 

 

 

28

8

 

12

 

 

70

 

6

 

9

 

 

10

 

 

70

10

5

Page 6
Image 6
ProForm PFCCEX17910 Bottom of the console, Wire harnesses, Holes in the Seat Post, Then release the Knob, To avoid