MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise cycle reg- ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap. Important: To avoid damage to the console, keep liquids away from
the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. Refer to assembly step 4 on page 5 for replacement instructions. Note: The con- sole requires four 1,5 V (D) batteries.
HOW TO LEVEL THE EXERCISE CYCLE
After the exer- cise cycle has
been moved to the location where it will be used, make sure
that both ends of front stabilizer
are touching the floor. If the exer- cise cycle rocks
slightly during use, turn one or both of the leveling feet under the front stabilizer until the rocking motion is eliminated.
HANDGRIP PULSE SENSOR TROUBLE-SHOOTING
•Avoid moving your hands while using the handgrip pulse sensor. Excessive movement may interfere
with heart rate readings.
•Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings.
•For the most accurate heart rate reading, hold the metal contacts for about 15 seconds.
•For optimal performance of the handgrip pulse sen- sor, keep the metal contacts clean. The contacts
can be cleaned with a soft
HOW TO MOVE THE EXERCISE CYCLE
To move the exercise cycle, first stand in front of the exercise cycle, hold the handlebars, and place one foot on the front stabilizer. Pull the handlebars until the exercise cycle can be moved on the front wheels. Carefully move the exercise cycle to the desired loca- tion and then lower it.
Handlebars |
Place |
Foot |
Here |
Wheel |
12
