10.Identify the Right Link Arm (39) and the Right Pedal Leg (38), which are marked with “R” stick- ers, and orient them as shown.
Apply a generous amount of grease to a Link Axle (47). Also, apply a small amount of grease to a 16mm Wave Washer (66). Slide the Link Axle through the Right Link Arm (39) and then slide the Wave Washer onto the right side of the Link Axle.
With the help of another person, slide the Right Pedal Leg (38) onto the right side of the Link Axle (47). Attach the Right Link Arm (39) and the Right Pedal Leg with two M8 x 25mm Button Screws (77), two Link Axle Covers (49), and two M8 x 25mm Washers (54).
Repeat this step for the Left Link Arm and the Left Pedal Leg (not shown).
11.Apply a generous amount of grease to the axle on the Right Upper Body Arm (37) and to the right Crank Arm (31).
Apply a small amount of grease to two 19mm Wave Washers (71). Slide one Wave Washer onto the Right Upper Body Arm (37); slide the other Wave Washer onto the right Crank Arm (31).
Identify the Right Pedal Leg (38) and Right Link Arm (39) assembly, which is marked with an “R” sticker. Orient the assembly as shown.
At the same time and with the help of another person, slide the Right Pedal Leg (38) onto the Right Upper Body Arm (37) and slide the Right Link Arm (39) onto the right Crank Arm (31).
Attach the Right Pedal Leg (38) and the Right Link Arm (39) with two M10 x 20mm Button Screws (58), two Axle Covers (46), and two M10 x 25mm Washers (52).
Repeat this step for the other side of the elliptical exerciser.
10 |
|
|
|
|
77 | 39 |
|
|
|
49 | Grease |
|
| |
|
|
|
| |
| 54 | 47 |
|
|
| 66 |
|
|
|
|
| 38 | 54 |
|
|
|
| 49 | 77 |
|
|
|
| |
11 |
|
|
|
|
|
| Grease |
|
|
|
| 71 |
|
|
|
| 37 | 52 |
|
| 31 | 39 | 46 | |
|
|
| ||
|
| 52 | 46 | 58 |
|
| 38 | ||
|
|
| ||
|
|
|
|
12.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
10
