1.

1

 

 

To make assembly easier, read the

 

 

information on page 5 before you begin

 

 

 

assembling the elliptical exerciser.

 

 

 

Attach a Wheel (8) to one side of the Frame (1)

 

 

 

with an M10 x 35mm Shoulder Screw (57).

 

 

 

Attach the other Wheel in the same way.

 

 

 

 

 

 

1

 

 

 

8

 

 

 

57

2. Apply a generous amount of the included

2

 

 

grease to the Pivot Axle (41). Then, insert the

 

 

 

 

 

Pivot Axle through the Frame (1).

23

 

 

 

 

 

Apply a small amount of grease to a 16mm

1

Grease

Wave Washer (66). Slide the Wave Washer

41

 

 

onto the right side of the Pivot Axle (41).

 

 

 

66

 

Identify the Right Upper Body Arm (37), which is

 

37

 

 

 

marked with an “R” sticker. Slide the Right

 

 

54

Upper Body Arm onto the Pivot Axle (41). Attach

 

 

the Right Upper Body Arm with an M8 x 25mm

 

 

44

 

 

 

Button Screw (77), a Pivot Axle Cover (44), and

 

 

 

an M8 x 25mm Washer (54).

 

 

 

Attach the Left Upper Body Arm (23) in the

 

 

77

 

 

 

same way.

 

 

 

3. Orient the Water Bottle Holder (6) as shown.

3

 

 

Hold the Water Bottle Holder near the Frame

 

 

 

 

74

(1) and insert the Wire Harness (73) upward

73

 

 

 

through the Water Bottle Holder.

 

 

 

Next, slide the Water Bottle Holder (6) onto the

6

 

 

 

 

 

Frame (1). Attach the Water Bottle Holder with

 

 

 

two M4 x 35mm Screws (74).

 

 

 

 

 

 

1

 

6

 

 

Page 6
Image 6
ProForm PFEL04907.0 user manual Attach the other Wheel in the same way, Attach the Left Upper Body Arm 23 Same way