8.Apply a generous amount of grease to the axle on the Left Crank Arm (36). Slide the Left Pedal Leg (13) onto the axle and secure it with an M8 x 35mm Patch Screw (47) and an M10.3 Black Washer (53).
Align the lower end of the Left Handlebar (9) with the free end of the Left Pedal Leg (13). Apply a generous amount of grease between the Left Handlebar and the Left Pedal Leg. Next, generously grease an M10 x 94mm Button Bolt (27). Attach the Left Handlebar to the Left Pedal Leg with the Button Bolt, two M10 Washers (38), and an M10 Nylon Locknut (29) as shown. Do not overtighten the Nylon Locknut; the
Left Handlebar must be able to pivot freely.
Attach the Right Handlebar (10) to the Right Pedal Leg (not shown) in the same way.
Refer to step 3. Tighten the M10 x 88mm Button Bolt (63).
8 |
|
|
|
| 10 |
|
|
9 |
|
|
|
38 |
| 29 |
|
Grease |
|
|
|
38 |
|
| 36 |
27 | 13 |
| Grease |
|
|
| |
|
| 47 | 53 |
|
|
|
9.Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Extra hardware may be left after assembly is completed. To protect the floor or carpet from damage, place a mat under the ellipti- cal crosstrainer.
8
