1.While another person lifts the front of the Frame (1), attach a Stabilizer (3) to the Frame with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (29).
2.While another person lifts the back of the Frame (1), attach a Stabilizer (3) to the Frame with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (29).
3.While another person holds the Upright (2) in the posi- tion shown, connect the Upper Wire Harness (20) to the Lower Wire Harness (19). Carefully pull the upper end of the Upper Wire Harness to remove any slack. While holding the upper end of the Upper Wire Harness, insert the Upright into the Frame (1). Be careful to avoid pinching the Wire
Harnesses.
Slide an M10 Split Washer (70) and a Frame Spacer (33) onto the M10 x 88mm Button Bolt (63). Make sure that the flat end of the Frame Spacer is facing the Split Washer. Insert the Button Bolt into the Frame (1) and the Upright (2). Do not tighten the
Button Bolt yet.
4.Connect the wire harness on the Pulse Sensor (35) to the indicated wire harness on the Console (5). Insert both wire harnesses into the opening in the bottom of the Console.
Refer to the inset drawing. Insert the metal tube on the Pulse Sensor (35) into the metal bracket inside of the Console (5) as shown. Be careful not to pinch the wire harnesses. Align the holes in the metal tube with the holes in the metal bracket, and tighten two M4 x 16mm Screws (66) into the indicated holes.
1 |
|
|
|
|
34 |
|
|
|
|
| 3 |
|
|
|
|
| 1 |
|
|
|
| 29 |
|
|
2 |
|
|
|
|
|
| 29 | 3 |
|
29 |
|
|
|
|
1 |
|
|
|
|
|
|
| 34 |
|
3 |
|
|
|
|
|
| Make sure the | ||
|
| Wire Harnesses | ||
|
| (19, 20) do not | ||
|
| get pinched and | ||
| 2 | damaged during | ||
| this step. |
| ||
|
|
| ||
63 | 70 | 20 |
|
|
33 |
|
| ||
|
| 19 |
|
|
|
|
| 1 |
|
4 |
|
| 5 | 35 |
|
|
|
| |
|
| 66 |
|
|
| 5 |
|
|
|
|
| Bracket |
|
|
|
| Tube | 66 |
|
|
| 35 |
|
|
Wire Harnesses |
|
|
| |
6
