ProForm PFEL8947.0 user manual Ing the Wire Harness 48 between Upright and the Frame

4. Have a second person hold the Upright (6) near	4
the Frame (2) as shown.
				48
Pull the Wire Harness (48) out of the Frame (2)				6
and insert it upward through the Upright (6). Do
not let the Wire Harness fall into the Upright; use				95
a piece of tape or an elastic band to hold the			100
Wire Harness in place until step 12.
Insert the Upright (6) into the Frame (2). Attach		95
				2
the Upright with three M8 x 16mm Button Screws
				100
(95) and three Star Washers (100). Avoid pinch-				95
ing the Wire Harness (48) between the
Upright and the Frame.
5. Orient the Left Roller Leg (12), which is marked	5		36
with a “Left” sticker, near the left Crank Arm (36)
		Grease
as shown.			98
Apply a small amount of the included grease to		30
		84
both sides of a Wave Washer (98). Slide the
Wave Washer onto the end of the left Crank Arm				21
(36). Next, slide the Left Roller Leg (12) onto the		80
Crank Arm and set the Roller (22) on the Base
		12
(1). Attach the Left Roller Leg with an M10 x
23mm Shoulder Screw (80), an M10 x 20mm x
1.5mm Washer (84), and a Crank Axle Cap (30).
Repeat this step to attach the Right Roller
Leg (21) to the right Crank Arm (not shown).				1
				22
6. Identify the Left Handlebar (8), which is marked	6
with a “Left” sticker. Insert the Left Handlebar into
				8
one of the Handlebar Legs (11) as shown.
Attach the Left Handlebar (8) with two M8 x				Hexagonal
				Hole
42mm Bolts (71) and two M8 Nylon Locknuts
(96). Make sure that the Nylon Locknuts are				96
inside the hexagonal holes.
		Hexagonal
Assemble the Right Handlebar (not shown)		Hole
and the other Handlebar Leg (not shown) in
the same way.		11
				71
	7