2.Slide the Stabilizer Cover (31) onto the Frame (1). Next, move and lift each Flex Bar (14) out of the way and slide the Stabilizer Cover onto the Front Stabilizer
(3). While another person lifts the front of the Frame, attach the Stabilizer Cover to the Front Stabilizer with two M4 x 52mm Screws (98).
3.With the help of a second person, carefully tip the elliptical exerciser onto one side.
Make sure that the Left and Right Stabilizer Endcaps (35, 92) are on the Rear Stabilizer (4).
Attach the Rear Stabilizer (4) to the Frame (1) with four M8 x 45mm Button Screws (102) and four M8 Split Washers (94).
With the help of a second person, carefully tip the elliptical exerciser back to the vertical position.
4.Have another person hold the Upright (2) in the posi- tion shown. Connect the Upper Wire Harness (86) to the Lower Wire Harness (87). Next, insert the Upright into the Frame (1). Be careful to avoid disconnect- ing or pinching the Wire Harnesses. Attach the Upright with two M8 x 54mm Button Screws (33), two M8 x 38mm Button Screws (70), and four M8 Split Washers (94). Be careful to avoid damaging the
Wire Harnesses with the Button Screws.
Attach the Water Bottle Holder (91) to the Upright (2) with two M4 x 16mm Screws (66).
Hold the Left and Right Handlebar Covers (26, 29) around the Upright (2) and the indicated tube. Press the Handlebar Covers together and connect them with an M4 x 16mm Round Head Screw (45).
Hold the Left and Right Upright Covers (34, 38) around the Upright (2). Attach the Upright Covers with two M4 x 14mm Round Head Screws (93).
6
2 |
|
| |
31 |
|
| |
1 |
|
| |
|
| 14 | |
14 |
|
| |
3 |
|
| |
| 98 |
| |
3 |
| 92 | |
|
| ||
| 4 |
| |
|
| 94 | |
| 1 | 102 | |
|
| 94 | |
|
| 35 | |
4 |
| 93 | |
|
| ||
|
| 38 | |
34 |
| 29 | |
|
| ||
93 |
| 45 | |
|
| ||
26 |
| Tube | |
|
| 91 | |
Make sure the |
| 66 | |
wire harnesses |
| ||
do not get | 2 |
| |
pinched and |
|
| |
damaged | 86 |
| |
during this | 87 | ||
step. | 94 | ||
94 | |||
|
| ||
| 70 | 33 | |
| 94 | ||
| 94 | ||
| 1 | ||
|
|
