Kenmore 170, 275 Install Covers, Restart Water Heater, Grounding / Connect to Electrical Power

SECTION3STEP BY STEP GUIDES TO INSTALL

F. GROUNDING / CONNECT TO ELECTRICAL POWER

_PLUG	IN	THE TRANSFORMER	CONNECTING	TRANSFORMER
Plug	the	transformer into the electrical	outlet.
			Transformer
				120V-6OHz
				Electrical
				Outlet

Power Cable

from Face Plat_'13mer

INSTALL COVERS

Salt Hole

(Main)

After installing your water softener, replace the cov-

ers. For the UltraSoft 100, first position the main

cover on the softener. Then, set the salt hole cover into the main cover, and lower closed. For the Ultra- Soft 200, angle the covers so the main cover clips onto the back first, then bring down in front and clip on the 2 tabs inside the rim of the salt hole and lower the salt cover closed.

				RESTART			THE WATER		HEATER
TURN ON THE GAS (OR ELECTRIC) SUPPLY TO THE WATER HEATER AND LIGHT THE PILOT
Your	new	Sears softener	is now	softening		the	water	To drain	the water heater, open a hot water faucet
for your household needs. However,					your WATER			and let it run until the water runs cold. Then close
HEATER		is filled with	hard	water.	To	have	fully	the faucet.
soft water right away, you can drain the water heat-
er so it refills with soft water. If you don't drain the
water heater, it will take a few days before you have
fully	soft	water.

YOUR PLUMBING AND ELECTRICAL WORK IS COMPLETE.

Now go to your owner's manual and do the softener start-up steps...setting the timer, filling the

storage tank with salt, sanitizing, etc.

3-9

Deluxe Valve