SECTION3STEP BY STE P G UIDES TO INSTALL

F. GROUNDING / CONNECT TO ELECTRICAL POWER

_PLUG

IN

THE TRANSFORMER

CONNECTING

TRANSFORMER

Plug

the

transformer into the electrical

outlet.

 

 

 

 

Transformer

 

 

 

 

 

120V-6OHz

 

 

 

 

Electrical

 

 

 

 

Outlet

from Face Plate-_mer

INSTALL COVERS

tabs

After installing your water softener, replace the cov-

ers. For the UltraSoft 400 and UltraSoft 800, angle the covers so the main cover clips onto the back first,

then bring down in front and clip on the 2 tabs inside the rim of the salt hole and lower the salt cover clo-

sed.

RESTART THE WATER HEATER

TURN ON THE GAS (OR ELECTRIC) SUPPLY TO THE WATER HEATER AND LIGHT THE PILOT

Your new Sears softener is now softening the water

for your household needs. However, your WATER HEATER is filled with hard water. To have fully soft water right away, you can drain the water heat- er so it refills with soft water. If you don't drain the water heater, it will take a few days before you have fully soft water.

To drain the water heater, open a hot water faucet and let it run until the water runs cold. Then close the faucet.

YOUR PLUMBING AND ELECTRICAL WORK IS COMPLETE.

Now go to your owner's manual and do the softener start-up steps...setting the timer, filling the

storage tank with salt, sanitizing, etc.

3-9

High Performance Valve

Page 40
Image 40
Kenmore 170, 275 installation manual Restart the Water Heater, Install Covers