ProForm PFEVEL29010 user manual Be careful to, Avoid pinching, Harnesses

1.Identify the Front Stabiliser (3), which has Wheels (32) attached to it. Whilst another person lifts the front of the Frame (1) slightly, attach the Front Stabiliser to the Frame with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (29). Make sure that the

Front Stabiliser is turned so the Wheels are not touching the floor.

2.Whilst another person lifts the back of the Frame (1) slightly, attach the Rear Stabiliser (4) to the Frame with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (29).

3.Whilst another person holds the Upright (2) in the posi- tion shown, connect the Upper Wire Harness (82) to the Lower Wire Harness (20). Carefully pull the upper end of the Upper Wire Harness to remove any slack from the Wire Harnesses.

Insert the Upright (2) into the front of the Frame (1) as shown. Be careful to avoid pinching the Wire Harnesses (20, 82). Slide an M10 Split Washer (70) and a Frame Spacer (19) onto the M10 x 88mm Button Bolt (63), and insert the Button Bolt into the Frame and the Upright. Make sure that the concave end of the Frame Spacer is turned toward the Frame. Hand tighten the Button Bolt into the welded nut on the Frame. Do not tighten the Button Bolt yet.

4.Connect the wire harness on the Handgrip Pulse Sensor (81) to the indicated wire harness on the Console (5). Insert both wire harnesses into the open- ing in the bottom of the Console.

Refer to the inset drawing. Insert the metal tube on the Handgrip Pulse Sensor (81) into the metal bracket inside the Console (5) as shown. Be careful not to pinch the Wire Harnesses. Align the holes in the metal tube with the holes in the metal bracket, and tighten two M4 x 16mm Screws (66) into the indicated holes.

1		32
34
32
	3
			1
			29
2
			29	4
29
1
				34
3			Be careful to
			avoid pinching
			the Wire
			Harnesses
			2
63			82
	70	19	20
				1
4				5	81
			66
	5
		Bracket
			Tube	66
			81

5