ASSEMBLY
To hire an authorized service technician to assemble the exercise cycle, call
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack- ing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included
hex keys, assembly requires a Phillips screwdriver 
and an adjustable wrench 
.
As you assemble the exercise cycle, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M6 Washer | M8 Split | M8 Nylon | M10 Nylon |
Washer | Locknut | Locknut | |
M4 x 16mm | M6 x 38mm Button |
| M6 x 42mm Button |
Round Head | Screw |
| Screw |
Screw |
|
|
|
M8 x 25mm Button | M8 x 70mm Button |
| |
| Screw | Bolt |
|
| M10 x 75mm Carriage Bolt |
| |
5
