![](/images/new-backgrounds/1122981/12298123x1.webp)
SPA JET UNIT OPERATION
The spa jet unit features three
The three
| B |
| A |
D | C |
The whirlpool jet (B), located on the left side of the spa jet unit, directs the flow of the water to create a whirlpool action in the RESTORATION 600.
The suction vent (C), located on the right side of the spa jet unit, pulls the water into the spa unit, in order to operate the system. The suction cover should always be in place over the suction vent. Never
operate the spa with- C out the suction
cover in place.
The filter (D), is locat- ed on the left side of the spa jet unit, behind the filter cover. The filter can be
removed for cleaning and replacement by removing the Filter
Cover and the two
filter cover screws and then pulling the filter from the spa jet unit.
The spa jet unit features an automatic filter cycle and freeze protection. If the spa jet unit has not been operated for three hours, the pump will begin circulat-
ing the water for twenty minutes to filter any impuri- ties. Also, if the water temperature falls below 40¡F, the pump will begin circulating and heating the water to prevent the water from freezing.
DRAINING THE RESTORATION 600
To drain the RESTORATION 600, you must use a garden hose to siphon the water. Place one end of the hose in the spa and hold it in front of a hydro- therapy jet until there is a flow of water coming out of the hose. Turn off the spa unit and unplug the power cord. The unit will be damaged if it is run without water circulating. Be sure the end of the hose in the spa is on the floor of the spa.
DRAINING THE PUMP
After the RESTORATION 600 is drained (see DRAIN- ING THE RESTORATION 600 above), the pump in the spa jet unit should also be drained if the spa will be stored for more than thirty days, or if it may be exposed to freezing temperatures.
To drain the pump, |
| |
remove the spa jet |
| |
unit from the side pan- | Pump | |
els. Be careful not to | ||
| ||
tear the inflatable |
| |
spa liner. Locate the |
| |
pump inside the spa |
| |
jet unit. Remove the | Drain Plug | |
drain plug from the | ||
pump. Tip the spa jet |
|
unit slightly, until all the water has drained from the pump. Replace the drain plug.
12