TROUBLE-SHOOTING

Most problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time.

1.SYMPTOM: THE SPA WILL NOT OPERATE

a.Check the power cord. The power cord must be plugged into a grounded outlet (see PLUG- GING IN THE RESTORATION 600 on page 10).

b.Check to see if the GFCI breaker is tripped, or was not turned on. Reset the GFCI breaker.

2.SYMPTOM: THE CIRCUIT BREAKER OR GFCI BREAKER TRIPS WHILE THE SPA IS OPERATING

a.Reset the circuit breaker. If the circuit breaker trips again, contact a qualified electrician for service.

3.SYMPTOM: THE PUMP HUMS

a.The filter may be dirty or damaged. Remove the filter housing from the spa jet unit and clean or replace the filter.

b.The pump may have a foreign object stuck in the impeller. Contact our customer service department.

c.The pump may have a loose wire connection. Contact our customer service department.

4.SYMPTOM: THE PUMP HUMS BUT DOES NOT ROTATE

a.The pump may be jammed. Contact our cus- tomer service department.

5.SYMPTOM: THE PUMP IS NOISY WHILE OPERATING

a.There may be debris in the pump. Contact our customer service department.

b.The pump may have a bad bearing. Contact our customer service department.

6.SYMPTOM: THE WATER DOES NOT HEAT

a.The heater is attached to the pump in the spa jet unit. If the pump is operating, the water should heat. Cover the RESTORATION 600

with the spa cover. The spa cover must be tight. Set the air control to low. The water will heat at a rate of 1.7¡F an hour. If you are using the spa indoors, and the room temperature is maintained at 70¡F, it will take approximately 20 to 28 hours for the water to reach the set temperature.

b. If you are using the RESTORATION 600 out- doors, it may take longer for the water to heat. See the chart below for the approximate heat- ing time.

Air Temperature

Heating Time

70¡F +

20 to 28 hours

50¡FÐ70¡F

1 to 2 days

30¡FÐ50¡F

2 to 3 days

b. If the water still has not heated after three days, contact our customer service department.

7.SYMPTOM: THE WATER IS NOT BEING CLEANED BY THE FILTER

a.Check to see if the filter is in place. Clean the filter if it is dirty.

b.Check the chemical balance of the water. If the pH is incorrect, the sanitizing agents will not function properly.

8.SYMPTOM: THE WATER PULSATES OR THERE IS MINIMUM WATER FLOW

a.Adjust the water level. This usually occurs only when the water level is low. Add water until the filter and jets are covered.

b.This problem is caused by excess air in the pump circulation system. Check to see if the primer cap is fully tightened. Prime the pump again and fully tighten the primer cap (see PRIMING THE SPA JET UNIT on page 10).

9.SYMPTOM: THE SPA JET UNIT CAVITATES DURING USE

a.Adjust the water level. This usually occurs only when the water level is low. Add water until the filter and jets are covered.

14

Page 13 Page 15
Page 14
Image 14
ProForm PFHS60070 user manual Trouble-Shooting
Page 13 Page 15

PFHS60070 specifications

The ProForm PFHS60070 is an advanced recumbent exercise bike designed to provide a comfortable and effective workout experience. Tailored for users of all fitness levels, this bike combines state-of-the-art technology with user-friendly features, ensuring a smooth and engaging exercise routine.

One of the standout features of the PFHS60070 is its adjustable seat. The seat is designed to accommodate various body types and preferences, allowing users to find their ideal riding position. This adjustability not only enhances comfort but also helps to improve workout efficiency by ensuring proper posture during exercise.

In terms of technology, this exercise bike includes a large, easy-to-read display that tracks essential workout metrics such as time, speed, distance, and calories burned. This real-time feedback motivates users to push themselves and reach their fitness goals. Additionally, the bike is equipped with built-in workout programs that cater to different fitness levels and preferences. With multiple pre-set options, users can easily switch up their routines to keep things fresh and exciting.

The PFHS60070 also features an ergonomic design focused on maximizing comfort during workouts. Its recumbent seating position supports the back and allows for a low-impact workout, making it an ideal choice for individuals with joint issues or those who prefer a more relaxed riding posture.

Another notable characteristic is its silent Magnetic Resistance system. This technology allows for smooth and quiet pedaling, ensuring that workouts can be done without disturbing others. Users can easily adjust resistance levels to increase workout intensity, accommodating both beginners and advanced users looking for a challenge.

Furthermore, the bike is equipped with integrated speakers and a port for mp3 players, allowing users to enjoy their favorite music or podcasts while exercising, enhancing the overall workout experience.

In conclusion, the ProForm PFHS60070 recumbent exercise bike is a versatile and feature-rich option for anyone looking to improve their fitness in a comfortable and engaging way. With its adjustable seat, advanced technology, ergonomic design, silent resistance system, and entertainment options, this bike is poised to become a valuable addition to any home gym.
Top Page Image Contents