ProForm PFRX35391 user manual Screws

5.Attach the Handlebar (4) and the Light Frame (82) to the Upright (2) with two M6 x 25mm Hex Head Screws (14) and two M6 Split Washers (67), but do not tighten the Screws yet. Make sure that the Screws are in the indicated holes. Note: Two more Screws will be attached in step 7.

Remove the backing from the Fastener Strip (77) and press it onto the Upright (2) in the position shown. Firmly press the Ballast Box (81) onto the Fastener Strip.

6.Connect the Reed Switch Wire (13) to the wire on the Console (8).

Next, attach the Console (8) to the Upright (2) with four #8 x 5/8Ó Screws (22).

Press the Resistance Knob (9) onto the Resistance Control (10). Be sure that the mark on the Knob is correctly aligned.

7.Finish attaching the Handlebar (4) and the Light Frame (82) to the Upright (2) with two more M6 x 25mm Hex Head Screws (14) and two more M6 Split Washers (67). Tighten all four Hex Head

Screws.

Remove the backing from the Cord Clips (95) and press them onto the Light Cycle in the indicated locations. Insert the Power Cord (73) into the Cord Clips. Make sure that the Power Cord cannot get caught on the pedals while you are exercising.

8.Attach the Seat Bracket (69) to the Seat Frame (3) with four M6 x 48mm Button Bolts (70) and four M6 Flat Washers (34).

8

5
		82
				14
	14		67
			67	4
	81	77	2
6		8		9
		Console
		Wire
		13
				10
	22		2
			22
7
				14
				67
		82
		14	4
		67
	73		2
		95
8			70	70
				34
			34	69
				3