3. Make sure that a qualified electrician has wired | 3 | |
the spa to a 240 volt power source. | ||
| ||
Remove the two warning decals (see page 5) from |
| |
the spa shell. Using a damp cloth, wipe the spa shell |
| |
clean. Before filling the spa, make sure that it is |
| |
in the desired position and that there is room to |
| |
easily service it. Once the spa is filled, it will |
| |
have to be drained before it can be moved. |
|
Insert a garden hose into the filter housing, and fill the spa. Do not use soft water. The spa may be filled with cold water; however, if warm or hot water is used, the spa will be ready for use sooner. Fill the spa until the water is at the level of the molded fill line. Do not overfill the spa.
See the inset drawing. Set the Filter (5) and the Basket (22) into the filter housing. Next, place the Filter Cover (3) into the filter housing until it is fully seated.
| 3 | |
Fill to here | 22 | |
| 5 | |
Garden | Filter | |
Hose | ||
Housing | ||
|
4.Pull down one of the straps on the Spa Cover (11) and hold the Buckle (26) against one of the panels on the spa. (Note: To position the Buckle correctly, have a second person hold the strap on the opposite side of the Spa Cover snug.) The Spa Cover must be snug. Do not place the Buckle over the grooves between the premium cedar panels.
See the inset drawing. Remove the latch from the Buckle. Attach the Buckle to the panel with two #4 x 3/4” Screws (27). Attach the other three Buckles (26) to the panels in the same way.
Remove the Spa Cover (11) from the spa.
4 |
Strap |
11 |
Latch |
26 |
27 |
Strap |
26 |
10
