Using the Controls
|
|
| Air Controls |
|
| Waterfall Valve | 1, 2, and 3 |
| |
|
|
| ||
|
|
| Waterfall | Waterfall |
|
|
|
| |
Blower | Mode | Waterfall Valve |
| |
|
| |||
Button | Button |
|
| |
|
|
| Display |
|
Pump | Pump | Light | Temperature |
|
Button 1 | Button 2 | Button | Buttons |
|
|
|
| for two minutes. “Std” displays momentarily when | |
|
|
| standard mode is selected. |
|
1 |
|
|
| • | Economy Mode heats the spa to the set tempera- |
|
| 1 |
| ture only during the filter cycles. “Ecn” is always dis- | |
2 | 1 |
| 4 |
| played when the actual temperature does not equal |
3 |
| 2 | |||
|
|
| the set temperature. “Ecn” alternates with the actual | ||
|
|
| 4 |
| |
|
|
| 4 | temperature when the actual temperature is the set | |
| 1 |
| 4 | temperature. | |
|
|
| |||
|
|
|
|
| |
|
| 3 | 2 | • | Sleep Mode heats the spa to within 20°F of the set |
4 |
| 2 |
| temperature during the filter cycles only. “Slp” is | |
|
|
|
|
| always displayed when the actual temperature does |
|
|
|
|
| not equal the set temperature. “Slp” alternates with |
|
|
|
|
| the actual temperature when the actual temperature |
|
|
|
|
| is the set temperature. |
Air control 1 determines the amount of air flowing through the hydrotherapy jets labeled 1 in the drawing above. If the control is turned counterclockwise, the amount of air will increase; if the control is turned clockwise, the amount of air will decrease. Air controls 2, 3, and 4 function in the same manner.
Air controls 2, 3, and 4 determine the amount of air flowing through the hydrotherapy jets labeled 2, 3, and 4 in the drawing above.
The Mode button switches the console between Standard, Economy, and Sleep modes.
•Standard Mode maintains the set temperature. Note: The actual temperature displayed will equal the set temperature only when pump 1 has been operating
Pump button 1 controls the spa jets labeled 3 and 4 in the drawing at the left. If the button is pressed once, the jets will run at low speed. If the button is pressed again, the jets will run at high speed. If the button is pressed a third time, the jets will shut off.
Pump button 2 controls the spa jets labeled 1 and 2 in the drawing at the left. If the button is pressed once, the jets will run. If the button is pressed again, the jets will shut off.The spa also features an automat- ic mode that heats and filters the water when the spa is left unattended. When the power to the spa is first turned on, or if the water temperature is below the set temperature, the water will be heated as required.
Note: To keep the filter and heat cycles from run- ning, the power to the spa must be turned off.
14
