5 Follow your progress with the LED track and the four displays.
LED
manual mode or the iFIT.com mode is selected, the program display will show a track representing a
distance of 1/4 mile. As
you exercise, the indicators around the track will light one at a time until the entire track is lit. A new lap will then begin.
Time/Segment Time
will show the elapsed time. When a preset
program or a pulse program is selected, the dis- play will show both the time remaining in the pro- gram and the time remaining in the current seg- ment of the program. The display will alternate be- tween one number and the other every seven sec- onds.
Pulse/Calories
sor is worn, the display
will also show your heart rate. The display will al- ternate between one number and the other every seven seconds. If the handgrip pulse sensor is used, the display will show your heart rate contin- uously while your hands are on the pulse sensor.
To use the hand- grip pulse sensor, stand on the foot rails and place your hands on the metal contacts on the handrail as
seconds, one or two dashes will appear in the Pulse/Calories display and then your heart rate will be shown. For the most accurate heart rate reading, hold the contacts for about 15 seconds.
Distance/Incline
incline level of the tread- mill. The display will al-
ternate between one
number and the other every seven seconds. Note: Each time the Incline buttons are pressed, the dis- play will change to show the incline setting.
Speed
Note: The speed can be
displayed in either miles per hour or kilometers per hour. The MPH or
Km/H indicator below the Speed display will light to show which unit
of measurement is selected. To change the unit of measurement, first hold down the Stop button while inserting the key into the console. The Speed display will show an E for English miles or an M for metric kilometers. Pressing the Speed + button will change the unit of measurement. When the desired unit of measurement is selected, re- move and then reinsert the key.
6 When you are finished exercising, stop the walking belt and remove the key.
Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest level. The incline must be at the lowest level when the treadmill is raised to the storage po- sition or the treadmill will be damaged. Next, re- move the key from the console and put it in a se- cure place. Note: If the displays and indicators on the console remain lit after the key is re- moved, the console is in the “demo” mode. Refer to page 20 and turn off the demo mode.
When you are finished using the treadmill, move the on/off switch near the power cord to the off position and unplug the power cord.
11
