4.Cut the tie securing the upper end of the Upright Wire Harness (17).
Have a second person hold the Console (78) near the Right Upright (10). Attach the ground wire from the Console to the Right Upright with the 1/2” Silver Screw (107).
Connect the Upright Wire Harness (17) to the wire har- ness on the Console (78). Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER IS TURNED ON. Insert the connectors into the Console.
5.Set the Console (78) on the Left and Right Uprights (9, 10). Be careful not to pinch any wires. See drawing 4 above. Make sure that the Upright Wire Harness (17) is not in the small cutout shown by the arrow.
Attach the Console (78) to the Uprights (9, 10) with six 3/4” Screws (39). Start all six Screws before tighten- ing any of them; be careful not to overtighten the Screws.
6.Lower the Uprights (9, 10) until the handrails are touch- ing the floor.
See the lower drawing. Position the Uprights (9, 10) so that the treadmill Frame (12) is centered between them.
Firmly tighten the four 2 3/4” Bolts (47). Then, raise the Uprights (9, 10) back to the vertical position.
4 | 78 |
|
|
| |
| Ground |
|
| Wire |
|
| 107 |
|
| 17 |
|
10 |
| |
|
| 17 |
5 |
|
|
| 78 |
|
|
| 9 |
39 |
| 39 |
|
| |
| 10 | 39 |
|
| |
6 |
|
|
| Handrail |
|
|
| 47 |
|
| 9, 10 |
Top View
10 | 9 |
12
8
