2.Identify the Right Upright (10), which has the Upright Wire Harness (17) inside of it. Orient the Right Upright as shown. Cut the band securing the lower end of the Upright Wire Harness.
Have a second person hold the Right Upright (10) near the Base (82). Connect the Upright Wire Harness (17) to the wire harness extending from the Base. Make sure to con- nect the connectors properly (see drawing 2a). The connectors should slide together easily and snap into place. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. See drawing 2b. Carefully wrap the wires around the connectors. Insert the connectors and the excess Wire Harness into the Base as shown, and then hold the Right Upright against the Base.
Be careful not to pinch the wires.
Insert two 2 3/4” Bolts (47), with two Washers (29) and two Star Washers (81), into the Base (82), and loosely thread the Bolts into the lower end of the Right Upright (10).
Attach a Wheel (95) to the Base (82) with a Wheel Bolt (86).
Do not overtighten the Bolt; the Wheel must be able to turn freely.
With the help of a second person, tip the treadmill onto its right side. Attach the Left Upright (9) and the other Wheel (not shown) as described above. Note: There are no wires in the Left Upright.
3.With the help of a second person, tip the treadmill onto the Base (not shown), with the Left and Right Uprights (9, 10) in a vertical position.
Open part bag B. Hold the Crossbar (88) between the handrails on the Left and Right Uprights (9, 10). Make sure that the square hole in the Crossbar is on top as shown. Attach the Crossbar with two Crossbar Bolts (56).
Firmly tighten the Crossbar Bolts.
2 |
|
|
|
| 10 |
82 |
| 17 |
|
| |
| 81 | 86 |
|
| |
|
| 9 |
47 | 29 | 95 |
| ||
| 29 |
|
47 |
| 81 |
2a | 17 | 2b |
|
|
3 |
9 |
56 |
88 |
10 |
Square |
Hole |
56 |
7
