7.Route the Upright Wire (28) through one of the Handrails (18) as shown.
Attach the Handrail (18) to the Right Upright (36) with two 5/16" x 2 1/4" Bolts (20) and two 5/16" Star Washers (19). Be careful not to pinch the
Upright Wire (28).
Attach the other Handrail (18) to the Left Upright
(31)with two 5/16" x 2 1/4" Bolts (20) and two 5/16" Star Washers (19). Firmly tighten the four 5/16" x 2 1/4" Bolts.
8.Insert the included plastic tie (A) through the in- dicated hole in the right Handrail (18). Make sure that the Upright Wire (28) is secured to the inside of the Handrail as shown. Then, tighten the plastic tie.
Remove the wire tie from the Upright Wire (28).
9.While another person holds the Console Base
(26)near the right Handrail (18), attach the ground wire on the Console Base to the right Handrail with a #8 x 1/2" Ground Screw (27).
Connect the wire harness on the Console Base (26) to the Upright Wire (28) as shown in the inset drawing. If the connectors are oriented correctly, they will slide together easily and snap into place. If they do not, turn one con- nector and try again. IF THE CONNECTOR IS
NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
7 | 20 |
|
|
| |
|
|
|
| ||
| 18 | 19 | 31 | 20 | 28 |
|
|
| |||
|
|
|
| 18 19 | 36 |
8 |
|
|
|
|
|
|
|
| 28 |
|
|
|
| A |
|
| Hole |
|
| 18 |
|
| |
|
|
|
| Wire Tie | |
9 |
|
|
| 26 |
|
Wire | 27 | Ground |
| Wire | |
Harness | 28 | Wire |
| Harness | |
|
| 18 |
|
| 28 |
9
