Locate the Reed Switch (62) and the Magnet (67) on |
|
|
the left side of the Pulley (64). Turn the Pulley until the | 1/8 in. |
|
Magnet is aligned with the Reed Switch. Make sure | 64 | |
that the gap between the Magnet and the Reed | 38 | |
Switch is about 1/8 in. (3 mm). If necessary, loosen | 62 | 67 |
the #8 x 3/4" Tek Screw (38), move the Reed Switch | ||
slightly, and then retighten the Screw. Reattach the | Top |
|
Hood (not shown), and run the treadmill for a few min- |
| |
utes to check for a correct speed reading. | View |
|
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a
b. If the walking belt is overtightened, treadmill perfor- b mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller bolts counterclockwise 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
c.If the walking belt still slows when walked on, please see the front cover of this manual.
PROBLEM: The walking belt is
SOLUTION: a. If the walking belt is |
|
|
|
|
|
| |
and UNPLUG THE POWER CORD. If the walking |
| a |
|
belt has shifted to the left, use the hex key to turn |
|
|
|
the left idler roller bolt clockwise 1/2 of a turn; if the |
|
|
|
walking belt has shifted to the right, turn the left |
|
|
|
bolt counterclockwise 1/2 of a turn. Be careful not to |
|
|
|
overtighten the walking belt. Then, plug in the power |
|
|
|
cord, insert the key, and run the treadmill for a few |
|
|
|
minutes. Repeat until the walking belt is centered. |
|
|
|
|
|
| |
b. If the walking belt slips when walked on, first remove |
|
|
|
the key and UNPLUG THE POWER CORD. Using |
| b |
|
the hex key, turn both idler roller bolts clockwise 1/4 |
|
|
|
of a turn. When the walking belt is correctly tightened, |
|
|
|
you should be able to lift each edge of the walking |
|
|
|
belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be |
|
|
|
careful to keep the walking belt centered. Then, plug |
|
|
|
in the power cord, insert the key, and carefully walk |
|
|
|
on the treadmill for a few minutes. Repeat until the |
|
|
|
|
|
| |
walking belt is properly tightened. |
|
|
|
21
