ProForm PFTL51230 user manual That the pin can be inserted fully into the hole. Hold

Models: PFTL51230

1 34
Download 34 pages 22.36 Kb
Page 9
Image 9

8. With the help of a second person, carefully tip the

8

 

 

 

Uprights (81, 82) down to the position shown.

 

 

81

 

 

 

 

 

 

 

Center the Frame (54) between the Uprights (81, 82).

 

 

 

 

Tighten the four 3 1/2” Bolts (90). Then, raise the

 

 

 

 

Uprights to the vertical position.

 

 

 

 

 

54

 

 

 

 

 

 

 

90

 

82

 

 

90

 

 

 

 

9. Remove the knob from the pin. Make sure that the collar

9

 

 

 

and the spring are on the pin. Insert the pin into the

 

 

 

 

 

 

 

Latch Housing (75), and tighten the knob back onto the

 

 

 

 

pin.

 

 

 

76

 

 

 

 

Raise the Frame (54) to the vertical position. While another

 

 

 

Hole

person holds the Frame, hold the Latch Housing (75)

 

 

 

 

against the inside of the Frame. Thread two 3/4” Screws

 

 

 

 

(6) several turns into the Latch Housing and the Frame.

 

 

 

 

Align the pin with the hole in the Left Handgrip (76) by

 

 

 

 

sliding the Latch Housing (75) up or down. Make sure

 

 

 

Pin

that the pin can be inserted fully into the hole. Hold

 

 

 

 

 

 

Collar

the Latch Housing in place and tighten the two 3/4”

 

12

 

 

 

75

Screws (6). Be careful not to overtighten the Screws.

 

 

54

 

 

6

 

 

 

 

 

 

 

Pull the knob to the right and carefully lower the Frame

 

 

Notch

 

(54) to the floor. Press the Latch Cover (12) into the left

 

 

Spring

side of the Frame. See the inset drawing. Make sure that

 

 

 

 

 

 

Knob

the notch in the Latch Cover is positioned on the Frame

 

 

 

 

 

 

 

as shown.

 

 

 

 

Note: After a period of use, the Latch Housing (75) may

 

 

 

 

need to be adjusted again to align the pin with the hole in

54

 

12

 

the Left Handgrip (76).

 

 

 

 

 

 

10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet, place a mat under the treadmill. If there is a sheet of clear plastic on a decal, remove the plastic.

9

Page 9
Image 9
ProForm PFTL51230 user manual That the pin can be inserted fully into the hole. Hold