![](/images/new-backgrounds/1271309/27130923x1.webp)
HOW TO TURN ON THE POWER
1 Plug in the power cord (see page 10).
2 | Locate the reset/off |
|
|
|
circuit breaker near |
|
|
| |
|
|
|
| |
| the power cord. Make |
| Reset |
|
| sure that the circuit |
| Position |
|
| breaker is in the reset |
|
|
|
|
|
|
| |
| position. |
|
|
|
|
|
|
|
Stand on the foot rails of the treadmill. Find the clip
3 attached to the key (see the drawing on page 11) and slide the clip onto the waistband of your clothes. Next, route the cord attached to the clip under the handgrip pulse sensor, and insert the key into the console. After a moment, the displays and various indicators will light. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.
HOW TO USE THE MANUAL MODE
1 Insert the key fully into the console.
See HOW TO TURN ON THE POWER above.
2 Select the manual mode.
When the key is in- serted, the manual mode will be selected
and the Manual indica-
tor will light. If a pro- gram has been
selected, press the Program Select button repeat- edly to reselect the manual mode.
Press the Start button or the Speed increase
3 button to start the walking belt.
A moment after the but-
ton is pressed, the walking belt will begin to move at 1 mph. Hold
the handrails and begin walking. As you exer-
cise, change the speed of the walking belt as de- sired by pressing the Speed increase and de- crease buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button
is held down, the speed setting will change in in- crements of 0.5 mph. To change the speed setting quickly, press the Quick Start buttons.
To stop the walking belt, press the Stop button. The Time/Pace display will begin to flash. To restart the walking belt, press the Start button or the Speed increase button.
Note: The first time the treadmill is used, observe the alignment of the walking belt, and align the walking belt if necessary (see page 27).
4 Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the Incline buttons. Each time
a button is pressed, the incline will change by 0.5%. Note: After the but-
tons are pressed, it may take a moment for the treadmill to reach the selected incline setting.
Follow your progress with the matrix and the
5 displays.
The matrix—When the
manual mode or the iFIT.com mode is se- lected, the matrix will display a
dicators around the track
will light in succession until the entire track is lit. The track will then darken and the indicators will again begin to light in succession.
Speed
Note: The console can
display speed and dis- tance in either miles or kilometers. To find which
unit of measurement is selected, press the Stop
button while inserting the key into the console. An “E” for English miles or an “M” for metric kilometers will appear in the display. Press the Speed in- crease button to change the unit of measurement. When the desired unit of measurement is selected, remove the key and then reinsert it. Note: For simplicity, all instructions in this manual refer to miles.
12