8.With the help of a second person, carefully tip the Uprights (81, 82) down to the position shown.
Center the Frame (54) between the Uprights (81, 82). Tighten the four 3 1/2” Bolts (90). Then, raise the Uprights to the vertical position.
9.Remove the knob from the pin. Make sure that the collar and the spring are on the pin. Insert the pin into the Latch Housing (75), and tighten the knob back onto the pin.
Raise the Frame (54) to the vertical position. While another person holds the Frame, hold the Latch Housing (75) against the inside of the Frame. Thread two 3/4” Screws
(6) several turns into the Latch Housing and the Frame.
Align the pin with the hole in the Left Handgrip (76) by sliding the Latch Housing (75) up or down. Make sure that the pin can be inserted fully into the hole. Hold the Latch Housing in place and tighten the two 3/4” Screws (6). Be careful not to overtighten the Screws.
Pull the knob to the right and carefully lower the Frame (54) to the floor.
Note: After a period of use, the Latch Housing (75) may need to be adjusted again to align the pin with the hole in the Left Handgrip (76).
8 | 81 | |
| ||
54 |
| |
| 90 | |
82 | 90 | |
| ||
9 |
| |
| 76 | |
| Hole | |
| Pin | |
| Collar | |
54 | 75 | |
6 | ||
| ||
| Spring | |
| Knob |
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet, place a mat under the treadmill. If there is a sheet of clear plastic on a decal, remove the plastic.
9
