ProForm PFTL517040 Assembly, Up righ t Bo lt 83, Bolt the Wheels must be able to turn freely

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dis- pose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver and

adjustable wrench . For help identifying assembly hardware, see the drawings below.

		Shock Nut	3/4”3/4￿TekScrew(65)–￿6
5/16￿	3/83/8”￿ Star		Wheel Nut
5/16” Star	Washer (87)￿4	(124)￿2
Washer (77)￿4		(124)–2	(20)￿2
Washer (77)–4	Washer (87)–4		(20)–2
Shock Bolt (116)–￿2			Latch Screw (74)–￿2
		Console Bolt (78)￿–44	2”￿ Screw (48)–￿2
Upright Bolt (83)–￿4			Wheel Bolt (94)￿–22

1.Make sure that the power cord is not plugged in. With the help of a second person, raise the Frame (38) to the vertical position; do not raise the Frame past the vertical position.

While the second person holds the Frame (38), attach the Right Rear Endcap (58) to the end of the Frame with a 3/4” Tek Screw (65). Be careful not to overtighten the Screw. Attach the Right Foot (117) to the bottom of the Right Rear Endcap with a 2” Screw (48).

Attach the Left Rear Endcap and the Left Foot (not shown) in the same way. Carefully lower the Frame to the floor.

2.With the help of a second person, carefully tip the tread- mill onto its left side. Partially fold the Frame (38) so that the treadmill will be more stable. Do not fully fold the treadmill.

Attach the four Base Pads (99) (only two are shown) to the bottom of the Base (69) with four 3/4” Tek Screws (65).

Attach a Wheel (95) to the Base (69) with a Wheel Bolt (94) and a Wheel Nut (20). Do not overtighten the Wheel

Bolt; the Wheels must be able to turn freely.

1117

65

48

58

38

2	38
	99		94
			99
65	69
		65
		20	95

6