6.Insert the excess Wire Harness (98, 128) into the Right Upright (107).
Set the console assembly on the Uprights (106, 107). While a second person holds the console assembly, at- tach the console assembly with four Console Bolts (78) and four 5/16” Star Washers (77) as shown. Start all four
Console Bolts before tightening any of them; firmly tighten the Console Bolts.
7.Lower the Uprights (106, 107) until the handrails are touching the floor.
See the lower drawing. Position the Uprights (106, 107) so that the treadmill Frame (38) is centered between the Uprights.
Firmly tighten the four Upright Bolts (83). Then, raise the Uprights (106, 107) back to the vertical position.
8.Attach the Latch Assembly (11) to the Left Upright (106) with the two Latch Screws (74). Start both Latch Screws before tightening either of them. Note: It may be necessary to remove the Latch Screws from the Left Upright before attaching the Latch Assembly.
6 | Console Assembly |
|
|
| |
| 98, 128 |
|
| 77 | 77 |
| 78 | 78 |
|
| |
| 107 | 106 |
|
| |
7 |
|
|
| 107, 106 |
|
83 
Handrail 
Top View
106 | 38 |
| 107 |
8 |
|
| 11 |
| 106 |
| 74 |
9.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 25). To protect the floor or carpet from damage, place a mat under the treadmill.
8
