ProForm PFTL54706.0 user manual Console Wire Bracket Tie Large Hole

Models: PFTL54706.0

1 32
Download 32 pages 42.62 Kb
Page 9
Image 9

7.Set the Console Assembly (91) face down on a soft surface to avoid scratching the Console Assembly. Hold the Right Handrail (33), which has a large hole in one side, near the Console.

Next, insert the console wire and the tie into the hole in the side of the Right Handrail (33). Using needlenose pliers, pull the console wire out of the hole near the bracket on the Right Handrail.

Then, set the Right Handrail (33) on the Console Assembly (91). Make sure that no wires are pinched. Start a Crossbar Screw (85) with a Crossbar Star Washer (7) into the Right Handrail, and then start two Console Screws (10) into the Right Handrail. Tighten the

Crossbar Screw and then tighten the two Console Screws; do not overtighten the Screws.

Attach the Left Handrail (not shown) to the Console Assembly (91) in the same way. Note: There are no wires on the left side.

8.See drawing 8a. If there is a guard on the end of the Console Wire, press the indicated tab and re- move the guard with needlenose pliers. Discard the guard.

With the help of a second person, hold the Console Assembly (91) near the Right Upright (54).

Remove the wire tie from the Wire Harness (39). Connect the Wire Harness to the console wire harness. Make sure to connect the connec- tors properly (see drawing 8b). The connec- tors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT

CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the connectors and the ex- cess wire downward into the Right Upright (54).

7

Console

 

 

 

 

 

 

Wire

85

 

 

 

 

Bracket

Tie

7

 

 

10

 

 

 

33

Large

 

 

Hole

 

 

 

 

 

 

91

 

 

8

 

 

8a

Console

Wire

Tab 91

Guard

39

Console Wire

8b

Harness

 

 

 

54

39

 

9.Attach the Console Assembly (91) to the Right Upright (54) and the Left Upright (53) with four four Handrail Bolts (8) and four Handrail Star Washers (5). Make sure that no wires are pinched. Start all four Handrail Bolts but do not tighten them yet.

9

91

 

 

 

 

8

8

 

5

5

 

54

53

9

 

 

Page 9
Image 9
ProForm PFTL54706.0 user manual Console Wire Bracket Tie Large Hole