10.With the help of a second person, hold the con- sole assembly near the Right Handrail (34) and the Left Handrail (not shown).
Connect the Upright Wire (38) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN YOU TURN ON THE POWER. Insert the connectors and the excess wire into the Right Handrail (34).
11.Connect the console ground wire to the handrail ground wire.
Set the console assembly on the Right Handrail
(34)and the Left Handrail (33). Make sure that the wire harnesses are not pinched. Attach the console assembly with ten #8 x 3/4" Screws
(12).Start all the Screws before tightening any of them.
Cut the plastic tie off the Right Handrail (34).
See steps 4 and 6. Firmly tighten the four 3/8" x 4" Bolts (6).
10 |
|
Console | Console |
Wire | Assembly |
38 |
|
34 |
|
| Console |
| Wire |
| 38 |
11 |
|
Console Assembly
33
Ground Wires
12 | Plastic | 12 |
| Tie | 12 |
| 12 | |
34 | 12 | 12 |
|
12.Identify the Storage Latch (53). Remove the tie from the end of the tube. Make sure that the sleeve has been slid over the indicated hole and that the Latch Knob (54) is locked into the hole.
Pull on the sleeve to make sure that it is locked into place.
12
| 54 |
Tube | Hole |
|
Sleeve
53
10
