ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrench 
and your own phillips screwdriver 
,
adjustable wrench 
, and rubber mallet 
.
Use the PART IDENTIFICATION CHART in the center of this manual to identify small parts as you assem- ble the treadmill. The hardware is divided into separate bags. Each bag is marked to show which assem- bly step uses the hardware. Note: Some hardware bags may include extra hardware.
1.Do not plug in the power cord until all assembly steps are completed.
With the help of a second person, carefully tip the treadmill onto its left side as shown. Partially fold the Frame (51) so that the treadmill will be more stable. Do not fully fold the treadmill until it is completely as- sembled.
Attach the six Base Pads (44) to the bottom of the Base (116) with six 1” Tek Screws (13). Note: Only three Tek Screws are shown.
2.Identify the Right and Left Uprights (55, 64); the Left Upright has two small holes near the square post. See drawing 2a. Make sure that there are two
Hold the Right Upright (55) near the Base (116), and ori- ent the Right Upright as shown. Make sure that the Right Upright bends in the direction shown. Straighten the Wire Harness (49), and feed it into the lower end of the Right Upright and out of the upper end. Make sure no wires are pinched. Hand tighten two Upright Bolts (112) with Star Washers (111) into the bottom of the Base (116) and the lower end of the Right Upright.
Attach the Left Upright (64) as described above. Note: There is not a wire harness on the left side.
3.With the help of a second person, carefully tip the tread- mill back down so that the Uprights (55, 64 [not shown]) are vertical. Make sure that the end of the Wire
Harness (49) does not fall into the Right Upright.
Set the Console Base (38) on the Right Upright (55) as shown. Check the pins in the connector on the Wire Harness (49) and make sure that they are straight. Connect the Wire Harness to the indicated connector on the back of the Console Base. Make sure to insert the connectors properly (see the inset drawing). The con- nectors should slide easily and snap into place. If the connectors do not slide easily and snap into place, turn one connector and try again.
1 |
|
|
| 51 |
|
13 | 44 |
|
|
| |
| 116 |
|
|
| 44 |
| 13 |
|
2 | 116 |
|
| 55 | |
| Holes | |
| Bend |
|
112 111 |
|
|
49 |
| 64 |
| 2a |
|
| 55, 64 |
|
| 100 |
|
3 |
|
|
38 | 49 |
|
| 49 |
|
55 |
|
|
6
