7.Have a second person hold the console assem- bly near the Right Upright (78). Remove the wire tie from the Upright Wire (38).
Connect the Upright Wire (38) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors into the Right Upright (78).
Set the console assembly on the Right Upright
(78)and the Left Upright (not shown). Attach the console assembly with four 5/16" x 1" Bolts (5) and four 5/16" Star Washers (9); start all four
Bolts and then tighten them.
8.Insert the Book Holder (88) into the console as- sembly; it may be helpful to rock the Book Holder up and down as you insert it. Attach the Book Holder with five 3/4" Black Screws (12); start all five Screws and then tighten them.
See steps 4 and 6. Tighten the 3/8" x 4" Bolts
9.If necessary, press the Left Tray (33) and the Right Tray (52) into the top of the console as- sembly.
7 |
|
|
Console |
|
|
Wire | Console | Console |
38 | Assembly | |
| Wire | |
9 |
|
|
5 | 9 | 38 |
| ||
78 | 5 |
|
| Wire Tie |
|
8 |
|
|
|
| 88 |
| Console Assembly |
| 12 | 12 | 12 |
|
|
| |
9 | 33 |
|
|
Console |
|
| |
|
|
| |
Assembly |
|
|
|
|
|
| 52 |
9
