ProForm PFTL59822 user manual Attach the Handgrip Extension with, Insert two 1/2 Screws 33 into

4.Loosely thread a 1/2” Tek Screw (113) into the left side of the Crossbar (46) and the Left Upright (64).

Attach the Latch Assembly (32) to the Left Upright (64) with two 3/4” Tek Screws (35).

5.Tighten a 1/2” Tek Screw (113) into the right side of the Crossbar (46) and the Right Upright (55).

Attach the Console Base (38) to the Uprights (55, 64) with four 1/2” Screws (33). Make sure that the Wire Harness (49) is not pinched.

6.Tighten the 1/2” Tek Screw (113) in the left side of the Crossbar (46).

Orient one of the Handgrip Extensions (34) so the bottom is

open as shown,	and insert it as far as possible into the
post on the left Upright (64). If necessary, tap the
Handgrip Extension with a rubber mallet to fully insert it.
Attach the Handgrip Extension with		two 3/4” Tek Screws

(35), one towards the front of the post and the other to- wards the back.

Attach the other Handgrip Extension to the post on the

Right Upright (not shown) in the same way.

7.See the inset drawing. Identify the Left Top Handgrip (31); there are identifying marks inside of the Handgrips. Set the Left Top Handgrip on the left Handgrip Extension

(34). Insert two 1/2” Screws (33) into	the two holes in
the Handgrip Extension indicated by the arrows.
Tighten the Screws into the Left Top Handgrip.
Important: Do not tighten the Screws into the plastic
bosses on the bottom of the Left Top Handgrip.

4
	113	46
	(Leave loose)
35	32
		64
5		38
49
33	113	46
		33	64
	55
6		113	46
	35
	Post
	34
		64	35

Open side

7	31
Bosses
33	31
34	43
64

7