TIME/INCLINE
elapsed time and the in-
cline level of the treadmill. Every seven seconds, the display will change from one number to the other, as shown by the arrows in the display. When a personal trainer program is selected, the display will show the time remaining in the program.
CALS./FAT CALS./
PULSE display—This
display shows the ap- proximate numbers of calories and fat calories you have burned (see
FAT BURNING on page 22). Every seven sec- onds, the display will change from one number to the other, as shown by the arrows in the display. The display will also show your heart rate when the pulse sensor is used (see step 6 on this page).
SPEED/MIN-MILE dis-
current pace (pace is measured in minutes per
mile). Every seven seconds, the display will change from one number to the other, as shown by the arrows in the display.
To change the unit of
measurement, hold down the STOP button while inserting the key into the console. An “E,” for
English miles, or an “M,”
for metric kilometers, will appear in the
6 Measure your heart rate, if desired.
Note: When using the pulse sensor, make sure that your hands are clean. The pulse sensor should also be kept clean with a damp cloth and mild detergent.
To measure your | Sensors | |
heart rate, stand | ||
| ||
on the foot rails |
| |
and place both |
| |
thumbs on the |
| |
pulse sensors as |
| |
shown. Do not |
| |
press too hard, |
| |
or the circula- |
| |
tion in your |
| |
thumbs will be |
| |
restricted and |
| |
your pulse will |
| |
not be detected. |
|
Next, wait until the
If the displayed heart rate appears to be too high or too low, or if your heart rate is not displayed, lift your thumbs off the sensors and allow the display to reset. Then, place your thumbs on the sensors as described above. Try the pulse sensor several times until you become familiar with it. Remember to stand still while measuring your heart rate.
7 Whenkey. you are finished exercising, remove the
Step onto the foot rails, press the STOP button, and adjust the incline of the treadmill to the lowest level. The incline must be at the lowest level when the treadmill is raised to the storage po- sition or the treadmill will be damaged. Next, remove the key from the console and put the key in a secure place. Note: If the displays and vari- ous indicators on the console remain lit after the key is removed, the console is in the “demo” mode. Refer to page 18 and turn off the demo mode.
When you are finished using the treadmill, move the on/off switch near the power cord to the off position.
11
