ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver 
and rubber mallet 
.
Note: The underside of the treadmill walking belt is coated with
1. With the help of a second person, carefully raise the | 1 |
|
|
treadmill to the upright position. |
|
| |
|
|
| |
While a second person tips the treadmill to one side |
|
|
|
and holds it, insert one of the Extension Legs (102) into |
|
|
|
the treadmill as shown. Make sure that the Extension |
|
|
|
Leg is turned so the Base Pad (99) is on the bottom. |
|
|
|
Next, tip the treadmill to the other side and insert the |
|
|
|
other Extension Leg (not shown) in the same way. Lower |
|
|
|
the side of the treadmill so that both Extension Legs |
|
| 102 |
(102) are resting flat on the floor. |
|
| |
|
|
| |
|
|
| 99 |
2. With the help of a second person, carefully lower the | 2 |
|
|
treadmill frame and then tip the Uprights (69) down as |
|
| |
|
|
| |
shown. Make sure that the Extension Legs (102) remain |
|
|
|
in the Uprights. |
|
|
|
Tighten two 3/4Ó Screws (100) into each Upright (69) and |
| 99 |
|
|
|
| |
Extension Leg (102). |
| Frame |
|
With the help of a second person, carefully tip the |
|
| 69 |
Uprights (69) back to the vertical position. |
|
| |
| 69 |
| 100 |
|
| 102 | |
|
|
| |
| 99 | 100 |
|
| 102 |
| |
|
|
| |
3. Using the included allen wrench, tighten the Pulse Bar | 3 |
|
|
Bolt (78) on each side of the treadmill. |
|
| |
|
|
| |
Find the plastic tie inside the post on the right Upright (69). |
| 76 |
|
| 67 | 78 | |
Insert the plastic tie through a Handrail Extension (66) and |
| ||
| Holes | ||
|
| ||
insert the Handrail Extension into the post as shown. Make |
|
| |
| Cutout |
| |
sure that the indicated holes are on top. Tap the Handrail |
|
| 69 |
Extension with a rubber mallet to fully insert it. Attach the |
| 75 | |
|
| ||
Handrail Extension with two 1/2Ó Screws (67) as shown. |
|
| |
| 66 | Post | |
|
| ||
|
|
| |
Identify the Right Foam Grip (75), which has a cutout in the |
| Tie |
|
left side for the Pulse Bar (76). Slide the Right Foam Grip as |
|
|
|
far as possible onto the post on the right Upright (69). |
|
|
|
6
