ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver 
, wire cutters 
and rubber mallet 
.
Note: The underside of the treadmill walking belt is coated with
1.With the help of a second person, carefully raise the Uprights (82) until the treadmill is in the position shown.
2. Remove the Lock Knob (110) from the Lock Pin (114).
Make sure that the Lock Pin Collar (112) and the Spring
(111)are on the Lock Pin as shown. Insert the Lock Pin into the Latch Bracket (77).
Tighten the Lock Knob (110) onto the Lock Pin (114).
3.Refer to drawing 3a. Press a Handrail Insert (102) into the lower end of each Handrail (85). Attach an Extension Leg (103) to the lower end of each Handrail (85) by loosely threading (3 or 4 turns) a Handrail Bolt (78) with a Handrail Washer (36) into each Extension Leg and Handrail as shown. Notice the angle of the Handrail Bolt in the drawings at the right; attach the Bolt and Washer at the observed angle. It should be the same as the angle of the Handrail (see drawing 3b).
1 |
|
|
|
| 82 |
2 |
|
|
110 |
|
|
77 |
|
|
| 111 | 112 |
|
| 114 |
3a | 3b |
|
85 |
| 85 |
|
| |
| 103 | |
102 |
|
|
103 |
| 36 |
36 |
| 78 |
78 |
|
|
6
