5.Press the Latch Housing (73) into the left Upright (84). Use a rubber mallet, if necessary, to fully insert the Latch Housing.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two col- lars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (73). Then, tighten the knob back onto the pin.
Plug in the power cord as described on page 12, and turn on the power as described on page 14. Note: The treadmill may automatically rise to the maximum incline level and then return to the minimum level.
6.Place the treadmill in the storage position (see HOW TO FOLD AND MOVE THE TREADMILL on page 24).
Next, place the cylinder end of the Shock (92) near the bracket on the base of the Uprights (84).
See the two small inset drawings. Using your fingernail or the end of a screwdriver, press on the end of the Shock Pin (25) to loosen it from the Shock (92). Next, ro- tate the Shock Pin and pull it out of the Shock. Be care- ful to avoid losing the Shock Pin.
See drawing 5a. Press the cylinder end of the Shock (92) onto the ball on the bracket. Next, insert the end of the Shock Pin (25) through two of the small holes in the end of the Shock. Then, rotate the Shock Pin until it clips onto the Shock.
7.Raise the Shock (92) to a vertical position. Remove the Shock Pin (25) from the raised end of the Shock as de- scribed in step 6. If necessary, rotate the Shock to align the end of the Shock with the ball on the bracket on the Frame (58).
Next, press the Incline increase and decrease buttons until the ball on the bracket is aligned with end of the Shock (92). Then, press the end of the Shock onto the ball. Note: It may be necessary to press the end of the Shock onto the ball while the Frame is moving.
See drawing 7a. Insert the Shock Pin (25) into the two in- dicated small holes in the end of the Shock (92). Then, rotate the Shock Pin until it clips onto the Shock. Note: Extra Shock Pins are included.
Press the Incline decrease button until the treadmill is at the lowest incline level. Then, unplug the power cord.
5 |
|
|
|
| Knob |
|
|
|
|
| Spring |
| 73 |
| Collar |
| 84 |
|
|
|
|
| Pin |
6 |
|
| 25 |
|
|
| |
| 84 |
|
|
| 25 |
|
|
| 92 | Bracket |
|
|
| 25 | |
|
|
| |
|
| Cylinder |
|
5a |
|
|
|
| 25 |
|
|
| 92 | Bracket | |
|
| ||
7 | 58 |
| |
|
| ||
|
| Bracket |
|
|
| 25 |
|
|
| 92 |
|
7a |
|
|
|
Holes
92
25
9
