ProForm PFTL91330 user manual as shown. Do not tighten the Screws yet, Assembly

3. With the help of a second person, raise the treadmill	3
Frame (55). Hold the Latch Housing (68) and the Latch
Housing Cover (5) against the sides of the Frame as
shown. Loosely thread the two blunt-tipped 1/2” Screws
(105) into the Latch Housing Cover and the Latch Housing
as shown. Do not tighten the Screws yet.		Hole	Knob
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. The collar should be on the			105
side of the spring shown. Insert the pin into the Latch	63
		68	5
Housing (68), and tighten the knob back onto it.
	20
			Small
Align the pin with the hole in the Left Handgrip (63) by slid-	Collar		Holes
ing the Latch Housing (68) up or down. Make sure that the
pin can be inserted fully into the hole. Hold the Latch			55
Housing in place as you tighten two 1/2” Tek Screws (20)	Spring
into the Latch Housing and the Frame (55). Then, tighten
	Pin
the 1/2” Screws (105). Note: It may be necessary to pull
on the knob to access and tighten the Screws.	105		20
4. Remove the backing from the indicated tape on the console	4	23
assembly. Press the Book Holder (23) firmly onto the tape.
	Console
	Assembly
		Tape

5.Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the treadmill to protect the floor or carpet. For your benefit, we recommend that you familiarize yourself with the TROUBLESHOOTING section on pages 23 and 24.

7